Industrial Footswitch with USB Output

Industrial Footswitch with USB Output; 6 Foot Length

This footswitch will plug directly into the computer USB port and send a gage read command to our GageMux^® when using your SPC software. Easy to use with our GageMux^® USB. This Footswitch works best when you send simultaneous gage readings in full comma delimited mode to your SPC data acquisition software.

There is no software to install to make this footswitch work. It works automatically once you have your SPC software active and sends a gage read command to the GageMux^® USB universal gage interface.

The output of this Industrial Footswitch is a standard USB 2.0 keyboard signal. It will allow the Footswitch to appear as a keyboard device that sends a gage read keystroke command from your SPC software package - no additional software wedge required.

High quality, industrial footswitch. Six foot cable length with standard USB connection. For use with our GageMux® and RS232 GageMux® where the computer is able to accept a USB data request.

Features:

• High quality with long cycle life

• Shop hardened

• USB 2.0 keyboard signal

• Six foot cable length. Special lengths available upon request.

• Plug and play. No set-up required